How To Change A Car Tyre

How To Change A Car Tyre. Use the lug wrench to loosen, but not remove, all of the lug nuts on the affected tire. Core equipment for changing a tire.

How To Change A Tyre YouTube from www.youtube.com

Ensure the ground is flat and free from gravel or mud. Place the jack under the car. Use the cross wrench to loosen all of the wheel.

Source: rosava.com

Use the vehicle owner’s manual to find the correct spot to place the jack. They need to be removed before changing the tyre.

Source: www.youtube.com

Place the new tyre on the axel, ensuring that you have lined up all the bolts. Use the wheel chocks to stabilise the vehicle.

Source: latestautoncars.blogspot.com

Turn them counterclockwise until you are able to loosen them by hand later. Avoid slopes and soft ground and park as far away from traffic as possible.

Source: www.artstation.com

Loosen the wheel nuts when the car is still on the level. If your flat tire is at the front, put the wheel wedges behind the rear tires.

Source: ideastand.com

Once the tyre is elevated off the ground continue to fully remove all the nuts and bolts. Avoid slopes and soft ground and park as far away from traffic as possible.

Source: valvolineexpresscare.ca

Place the new tyre on the axel, ensuring that you have lined up all the bolts. Apply slight leverage to the entire circumference of the hub cap until it loosens and comes off easily.

Source: audiocityusa.com

Use the lug wrench to loosen, but not remove, all of the lug nuts on the affected tire. Bring the car fully down to earth and remove the jack.

Once The Tyre Is Elevated Off The Ground Continue To Fully Remove All The Nuts And Bolts.

These go on either side of the tyre that’s diagonally opposite the flat wheel position. Some would think that since the vehicle is in park it will prevent the tire. They need to be removed before changing the tyre.

Use The Jack To Lower The Car Until It Makes Firm Contact With The Ground.

It’s important to not discard your old, punctured tyre and give it to your dealership or garage. Use the spare tyre you have in your car to replace the damaged tyre. This can allow them to check on the cause of the puncture, and find out.

Place The Tyre On The Wheel Hub.

The lug nuts should be initially loosened on the ground prior to the vehicle being jacked. Avoid pulling over near sharp turns, and crests of hills. Drive to the side of the road and find a spot to park the car.

Once This Final Nut Is Removed, The Tyre Should Slide Out Of Position.

Remove the tyre and place out of the way of your working area and any oncoming traffic or pedestrians. Use the cross wrench to loosen all of the wheel. Place the jack under the car.

If Your Flat Tire Is At The Front, Put The Wheel Wedges Behind The Rear Tires.

If the lug nuts require a good amount of torque the tire will spin instead of the nut. Put your car into first gear in your car and then apply the handbrake. With tyres changed, they can rejoin the race and have crofty talk about those same tyres for the next hour.